Samsung SCC-3000 - Manual (Page 8)

《8》
Names and Functions of Each Part
(2) Number Pad
※ 'F' in the table below refers to the Function button.
① 0 ~ 9 : Used for entering camera ID, channel number, monitor number, DVR ID, etc.
(see p.23).
② F + 0 : Activates the system setup menu (see p.24).
③ ▲ / ▼ : Used for increasing or decreasing menu values in detailed setup menus.
※ When using functions that are performed by a combination of the function button and
numeric keys, the setup may be different depending on the camera manufacturer.
Please refer to the table below for the setup for major camera manufacturers.
(3) External Device Selectors
① PTZ : Selects the PTZ mode (see p.15~24).
② DVR : Selects the DVR mode (see p.25).
③ CAMERA : Enter camera number and press the CAMERA button to set the camera ID (PTZ mode) or set the channel
(DVR mode).
④ MONITOR : Not used; will be applied to F/W in the future).
SPD-1600 SPD-2200 SPD-2500 PELCO-D
PANASONIC
(WV-CS854A)
SAMSUNG ELECTRONICS
(SCC-643/641)
TRACE RUN F+1 TRACE RUN TRACE RUN
TRACE RUN
(PATTERN)
TRACE RUN
(PATTERN)
TRACE RUN
(PATTERN 1)
TRACE
MEMORY
F+2
TRACE
MEMORY
TRACE
MEMORY
- F2(SPECIAL 2)
TRACE RUN
(PATTERN 2)
TRACE
MEMORY STOP
F+3
TRACE
MEMORY STOP
TRACE
MEMORY STOP
- F3
TRACE RUN
(PATTERN 3)
F+4
AUTO
POWER ON
AUTO
POWER ON
AUTO
POWER ON
- AUTO-SORT -
F+5
AUTO
POWER OFF
AUTO
POWER OFF
AUTO
POWER OFF
- - -
※ Use the AUTO POWER ON setting to allow the camera to resume the tasks in its memory upon power supply, even if
they were previously aborted as a result of power failure, etc.