SysKonnect SK-9E21D - Manual (Page 28)

30 3 Installation of the Driver Software
11. To copy the driver to the server, select Y ES .
If an older version of a SysKonnect driver is installed on the system, the messages “
Save
existing file SYS:SYSTEM\<driver name.LAN?
” and “
Save existing file
SYS:SYSTEM\<driver name>.LDI?
” are displayed.
12. To continue, select the desired options (Y ES or N O ).
The menu “Board SK-98NW_1 (Driver <driver name>) Actions” is displayed.
13. Select S ELECT M ODIFY D RIVER P ARAMETERS /P ROTOCOLS .
14. Configure the protocols to be used.
15. Configure the parameters, e.g. “slot number”.
16. After the parameters have been configured, select S
AVE P ARAMETERS AND L OAD D RIVER .
The driver is loaded.
Once the driver has been installed, the adapter parameters or bindings can be changed
in the autoexec.ncf file using the “Install” tool.
For more information, refer to the corresponding readme file.
Installation on Novell NetWare 5 and 6
The installation procedure for NetWare 5 and 6 is identical.
To install the network driver on Novell NetWare 5 or 6, proceed as follows:
1. After you have installed the adapter in your computer (for details, see chapter 1 "Installa-
tion of the Network Adapter"), boot NetWare 5 or 6.
NetWare detects the new adapter and tries to install a driver.
2. To get a list of available drivers, press <Enter>.
The menu “Select a driver” is displayed.
3. To install an unlisted driver, press <Insert> (the SysKonnect driver is not listed).
4. To specify the path to the driver, press <F3>.
The window “Specify a directory path” is displayed.
5. Type the path to the driver.
If you are installing from CD-ROM, the menu “Select an action” is displayed. Here, select
C
ONTINUE AND A CCESS THE CD-ROM.
The menu “Select a driver to install” is displayed.
6. Select the driver for your network adapter.
The message “
Do you want to copy driver <driver name>.LAN?
” is dis-
played.
7. To copy the driver to the server, select Y ES .
If an older version of a SysKonnect driver is installed on the system, the messages “
Save
existing file SYS:SYSTEM\<driver name.LAN?
” and “
Save existing file
SYS:SYSTEM\<driver name>.LDI?
” are displayed.
8. To continue, select the desired options (Y ES or N O ).
The menu “Board SK-98NW_1 (Driver <driver name>) Actions” is displayed.
9. Select S ELECT M ODIFY D RIVER P ARAMETERS /P ROTOCOLS .
10. Configure the protocols to be used.
11. Configure the parameters, e.g. “slot number”.
12. After the parameters have been configured, select S
AVE P ARAMETERS AND L OAD D RIVER .
The driver is loaded.
Once the driver has been installed, the adapter parameters or bindings can be changed
in the autoexec.ncf file using the “Nwconfig” tool.
For more information, refer to the corresponding readme file.