Resetting the system, Intercom and transfer – Skype Digital Enhanced Cordless Communication User Manual

Page 16

Advertising
background image

15

2. Select < User Status > under Skype mode;
3. Press Left key, then the display shows the selection status;
4. Press Scrolling button to select the status you wish to set;
5. Press Left key to save.

To Set Skype Microphone and Speakerphone

1. Right click on the Skype DECT icon

located at the bottom-right hand side;

2. Select Volume Control;
3. Set the Speaker or MIC as required. Illustration below.

To Make a Skype Conference Call:

1. When you already engaged on an ongoing call, if another Skype call is received,

press Right key to enter option menu;

2. Then press Scrolling button to select Hook up and press Left key;
3. Press Right key to enter option menu again;
4. Press Scrolling button to select Conference Call;
5. Press Left key to connect the three parties together.

Resetting the system

If you have set a PIN and forgotten it, you need to reset the system. The Base PIN will
be reset to 0000. If you reset the system, you will lose all stored information (including
numbers in memory) and all features will return to their default settings. You need to
register the handset to the base unit again.
While you are resetting the system, you should disconnect the telephone line cord from
the back of the base unit, so you won't be interrupted by incoming calls. To reset the
system without the PIN:

1. Disconnect the power lead from the back of the base unit
2. Press and hold the HANDSET LOCATOR button in the base unit, at the same time

connect the power lead into the back of base unit. Release the LOCATOR button
after you hear “beep” sound for five times. The IN USE light on base unit lights
during this whole process.

3. After 2~3 seconds, you can hear “beep” sound for two times again and the IN

USE light goes off;

4. Disconnect the power lead from base. Reconnect and you will hear a confirmation

tone from the base unit.

Intercom and transfer

To Make an Intercom Call

1. Press the INT key. You hear Dial tone
2. Key in the number of the other handset

Note: You cannot host a conference call by yourself but can be invited to

participate in a conference call opened by the other Skype users.

Advertising