Skype Digital Enhanced Cordless Communication - Manual (Page 18)

17
The phone does not ring
Check that the base unit’s mains power adapter is plugged in and power is switched on.
The base unit needs mains power for normal operation of the phone-not just charging the
batteries.
Make sure you are using the telephone line cable that was supplied with your telephone.
Other telephone line cables might not work.
Check that you have set the ringer volume to off. See the user manual for more
information.
Check that the total REN value of all equipment connected to your telephone line is no
more than 4. Disconnect one or more telephones and see whether that helps.
The base does not ring.
Check that the base power is ON, and the base ringer is set ON.
Check that the line cord is correctly fitted and undamaged.
The CHARGE light on the base unit does not come on."
Check the handset is properly stationed.
Check the connections between the base unit and mains power socket.
Clean the batteries charging contacts with a dry cloth.
When I press the CALL button, I hear a loud noise.
The strange noise is caused by interference. Disconnect the mains power lead from the
back of the base unit, and then wait for 30 seconds before reconnecting it.
There is 'beep' sound while I am on a call.
You may be going out of range of the base unit. Move closer, or your call may be cut
off.
Check the Batteries Level symbol on the display. If it is low, recharge the batteries.
The Caller Display feature isn’t working.
You need to subscribe to the Caller Display feature from your service provider.
The caller may have withheld their number, or they may be calling from a network that
does not transmit the Caller ID (for example, it may be an international call).
The handset’s batteries are running low within an hour or two.
Before you used the handset for the first time, you should have left it on the base unit
for up to 15 hours to charge the batteries fully. You may need to replace the batteries.
I cannot transfer a call.
Make sure the other handset is within range of the base unit, and is not busy on a call.
Make sure you are keying in the correct number for the other handset.
No display on LCD screen.
Make sure the batteries have power.
I cannot register handset to base
Make sure the number of handset registered to base is less than 3.
Check that the base unit is not near other electrical equipment, such as TV or computer
Technical details
Full DECT GAP Compatible system
Standard Digital Enhanced Cordless Telecommunications (DECT)
Frequency range 1.88 to 1.9 GHz
Channel bandwidth 1.728 MHz
Modulation GMSK
Operating range Up to 300 m outdoors; Up to 50 m indoors
Operating time Standby time: 100 hours, Talking time: 8 hours
Temperature range Operating 0 0 C to 40 0 C, Storage -20 0 C to 60 0 C