Sierra Wireless 20070914 - Manual (Page 141)

Configuration Commands
Rev 3.0B Feb.08 128
S5=n
This register sets the character recognized as a backspace
during command entry. Cannot be configured in AceManager.
• n=0‐127 (ASCII character number)
S6=n
This register denotes the wait time, in seconds, before a blind
dial (no dial tone detection). Cannot be configured in
AceManager.
• n=2‐10 seconds
S8=n
Whenever a dial command contains the comma character, the
contents of this register specify the pause time for each comma.
Cannot be configured in AceManager.
• n=0‐255
S9=n
Specifies the time that the received carrier must be present for
the modem to recognize it and turn on Data Carrier Detect
(DCD) if applicable. The implementation is entirely at the IWF
modem. Cannot be configured in AceManager.
• n=0‐255
S10=n
Specifies the amount of time that the carrier from the remote
modem can be lost before the modem goes on‐hook. This
allows temporary disruptions to carrier without disconnecting.
A setting of 255 causes the modem to disable Carrier Detect
and presume carrier is always present. Cannot be configured
in AceManager.
• n=1‐2545
S23=[speed],[databits][parity][stop bits]
Serial line parameters. The settings take affect after reset.
• speed=300 | 1200 | 2400 | 4800 | 9600 | 19200 | 38400 |
57600 | 115200 | 230400
• databits=7 or 8 (Databits MUST be 8 data bits for PPP
mode.)
• parity=O : Odd
• parity=E : Even
• parity=N : None
• parity=M : Mark
• stopbits=1 | 1.5 | 2