Sierra Wireless 20070914 - Manual (Page 77)

Data Communication and Host Modes
Rev 3.0B Feb.08 64
You can configure a string of AT commands to be sent to the
PinPoint X when it enters PassThru and other PassThru
settings.
Figure 8-2: AceManager : PassThru
PassThru Mode allows only specific AT commands. Some
ALEOS commands will be unavailable when the PinPoint X is
in PassThru mode. The commands usable also depend heavily
on the modem model number (found on the label on the top of
the PinPoint X).
Note: Some internal hardware requires upwards of 20 seconds
before AT commands can be entered, so be patient if there seems to
be no response to AT commands.
Telnet Mode
In AceManager you can configure Telnet operation.
Figure 8-3: AceManager : S0
If you need to change the port for Telnet (for example, you
have the default port blocked on your firewall), the option is
on the Other tab. The default telnet port is 2332. You can also
change the Telnet timeout, if the connection is idle, default 2
minutes.