Sierra Wireless 20070914 - Manual (Page 70)

PinPoint X HSDPA
57 20070914
Getting Immediate Reports Using RAP
You can set up the PinPoint X to report immediately report the
state of an input when it changes by using *PPFLUSHONEVT.
You will also need *PPINPUTEVT, input event reports,
enabled and a server configured for your RAP reports. These
settings are in the PinPoint group in AceManager.
Figure 7-8: AceManager : PinPoint - *PPFUSHONEVT / *PPINPUTEVT
Power Modes and Information
The PinPoint X can be configured to switch power modes in
response to specific events, such as when the voltage to the
modem drops below a configured threshold or when the DTR
changes, in order to conserve a vehicleʹs battery life. The stand‐
by state, low‐power mode, will prevent the modem from
draining the battery while allowing the modem to quickly
power up to regular operation when it is needed.
You can configure Low Power mode using AceManager.