Installing the usb driver, Installing the usb, Driver – Sierra Wireless 20070914 User Manual
Page 55: Set the port type, Connect the pinpoint x to your computer’s usb port
Universal Serial Bus (USB)
Rev 3.0B Feb.08
42
Installing the USB driver
1. Set the Port Type
Virtual Ethernet port is the default setting for the USB port. If
you want to install the virtual serial port, change the USB port
configuration using the directions above.
2. Connect the PinPoint X to your
computer’s USB port
When you connect the PinPoint X for the first time to a USB
port on your computer, Windows should detect a new device
and prompt you to install the driver.
Note: Windows will see each port type as a different USB device and
will see every port on your computer separately. If you change the port
type on the PinPoint X or connect to a different USB port on your
computer or hub, Windows will see it as a new device.
Figure 6-2: Found New Hardware Wizard
a.
To start the install of the USB virtual Ethernet driver,
select No, not this time and click Next.
b.
Select Install from a list of specific location and click
Next.