Hardware identification chart, Part no. and description qty – Stamina Products Orbital Rower 1215 User Manual
Page 6
6
Part No. and Description
Qty
HARDWARE IDENTIFICATION CHART
This chart is provided to help identify the hardware used in the assembly process. Place the washers, the
ends of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
mm.
in.
INCHES
MILLIMETERS
1
1/2
0
2
1/2
3
1/2
4
1/2
5
1/2
6
1/2
0
10
20
30
40
50
60
70
80
90
100
110 120
130 140 150
6
8
10
12
3/16"
5/16"
1/2"
3/8"
1/4"
length
length
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
43
Bolt, Hex Head (M8 x 1.25 x 16mm)
8
44
Bolt, Hex Head (M8 x 1.25 x 40mm)
4
45
Bolt, Hex Head (M8 x 1.25 x 55mm)
2
46
Bolt, Hex Head (M10 x 1.5 x 95mm)
1
48
Screw, Round Head (M4 x 10mm)
2
51
Nylock Nut (M8 x 1.25)
6
52
Nylock Nut (M10 x 1.25)
1
53
Acorn Nut (M10 x 1.25)
2
55
Lock Washer (M8)
8
56
Lock Washer (M10)
2
57
Washer (M8)
6
58
Washer (M10)
2