Stamina Products Orbital Rower 1215 - Manual (Page 7)

ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please call
our toll-free number for assistance 1 (800) 375-7520 or e-mail us at:
[email protected]
7
STEP 1
Insert the PEDAL SHAFT(21) through holes located on the front end of the CENTER BEAM(1). Place a
SPACER(22) and a PEDAL(23) onto each end of the PEDAL SHAFT(21) and slide them toward the CENTER
BEAM(1). Then secure the PEDALS(23) with WASHERS(M10)(58), LOCK WASHERS (M10)(56), and
ACORN NUTS(M10x1.5)(53) at both sides of the PEDAL SHAFT(21).
NOTE:
STEP 2
Insert the PEDAL STRAPS(24) into the slots in the bottom of the PEDALS(23). When feet are in the
PEDALS(23), the ends of the PEDAL STRAPS(24) will be facing away from the CENTER BEAM(1) as
shown above.
You need to use two Wrenches to tighten the ACORN NUTS(M10x1.5)(53) at both ends of the
PEDAL SHAFT(21) at the same time.