Solid State Logic X-Logic Series - Manual (Page 12)

Page 8
X-Rack Owner’s Manual
4. Operation - Total Recall
4.1 Overview
The Total Recall computer stores all of the switch and rotary control
positions for each X-Rack module in one of thirty two internal stores.
These can be recalled and compared with the current settings using
front panel LEDs to show which controls do not match. If the module
layout has changed since the snapshot was taken, only the modules
that match will be recalled.
The contents of all the stores can be archived and restored as a MIDI
system exclusive data dump.
Additionally the X-Rack can interface with the Total Recall system on
an AWS 900 or AWS 900+. This allows the settings of up to three X-Rack
units to be stored along with the AWS 900 settings.
Note. Through the rest of this manual, references to ‘AWS 900’ apply equally to
‘AWS 900+’.
4.2 Stand-alone Mode
4.2.1 Saving Stores to Internal Memory
A maximum of 32 stores can be saved in internal non-volatile memory, provided the stores have not been
write-protected – indicated by the ‘Wr Prot’ LED being illuminated.
First select a store by turning the D-Pot , then press SAVE to
store all of the current control positions.
If the store has already been used the SAVE LED will flash. Press the
SAVE switch a second time to overwrite the store.
4.2.2 Recalling and Displaying Stores
To select a store using the D-Pot then press the D-Pot to select that store.
The current store is displayed on the dual 7-segment display .
If the selected store is empty the ‘Empty’ LED lights and the unit will not switch to display mode.
With a valid store selected, the X-Rack module SEL LEDs will light if the module type in the store (EQ,
Dynamics etc.) matches the module currently fitted in that slot. A flashing SEL LED indicates that some controls
on that module do not match the stored positions. A steady LED shows that all controls are matched. The
switch LEDs will light if the current switch position does not match the stored positions. Press or release
the switch as required to extinguish the LED.
Above each rotary control is a bi-colour LED:
The LED extinguishes when the control matches the stored position.
If a store is already being displayed when you select a different store the display will flash and the new
store will not become active until you press the D-Pot for a second time.
4.2.3 Exiting Display Mode
Push the D-Pot a second time to exit display mode.
All SEL LEDs will extinguish and the channel switch LEDs will now show the position of their respective
switches.
4
The LED lights red if
the control needs
turning anti-clockwise.
or
The LED lights green if
the control needs
turning clockwise.
2
1
4
5
4 5
Push to Select
SAVE
3
SETUP/
MIDI
SAVE
Push to Select
COPY/
DEL
TOTAL RECALL
Empty
Wr Prot
1
7 6 5
4
3
2