Sanyo CLT-J30 - Manual (Page 10)

10
Before using this telephone, 7 initial settings must be completed on the
handset: Language, Area code (this is required to use Caller ID service
from your telephone company), Ringer tone, Tone/Pulse setting, LCD
contrast, Do Not Disturb (DND), and Idle Animation.
Language setting
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG until “ 1 ENG 2 FRA 3 ESP” shows on screen.
3. Press CID/VOL or , or the number keys (1 – 3) to select the
desired language.
4. Press FLASH/PROG to store selection. You will hear a confirmation
tone.
Area code setting
For proper Caller ID operation, you must program your area code.
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG until “AREA CODE - - - “ shows on screen.
3. Enter your 3-digit area code using the number keys. To change a
digit, press CH/DEL and then re-enter the number.
4. Press FLASH/PROG to store selection. You will hear a confirmation
tone.
Ringer tone
There are 6 melody ringer tones available for models J50 and J60 or 3
tones for J30, J40 and J40(BK).
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG repeatedly until “RINGER TONE 1” shows on
screen.
3. Press CID/VOL or , or press the number keys 1-3 or 1-6
(depending on the model) to select the desired ringer tone.
4. Press FLASH/PROG to store selection. You will hear a confirmation
tone.
Note: If type1-type 4 (melody) is selected, the handset melody will
continuously ring for 11 seconds after the line is dropped or a
parallel phone picks up the line.
Tone/pulse setting
1. Make sure the phone is off (not in TALK mode).
2. Press FLASH/PROG until “ 1 TONE 2 PULSE” shows on screen.
3. Press CID/VOL or , or press the number keys 1-2 to select
TONE or PULSE.
4. Press FLASH/PROG to store selection. You will hear a confirmation
tone.
INITIAL PROGRAMMING