Sanyo CLT-J30 - Manual (Page 27)

27
CALLER ID
No display
•
Is battery fully charged? Try replacing the battery.
•
Make sure that the base is connected to a non-switched AC outlet.
Disconnect the base from the plug and plug it in again.
•
Did you order Caller ID service from your local telephone company?
The display will not work unless you do this.
Caller ID error message
•
The phone displays this message if it detects anything other than
valid Caller ID information during the silent period after the first
ring. This message indicates either the presence of noise on the
line, or that an invalid message has been sent from the telephone
company.
TELEPHONE
No dial tone
•
Check installation:
- Is the base power cord connected to a working outlet?
- Is the telephone line cord connected to the base unit and the wall
jack?
•
Disconnect the base from the wall jack and connect another phone
to the same jack. If there is no dial tone in the second phone, the
problem might be your wiring or local service.
•
Is the handset out of range of the base?
•
Make sure the battery is properly charged (12 continuous hours).
•
Is the battery pack installed correctly?
•
Did the handset beep when you pressed TALK/CALL BACK? Did
the CHARGE/IN USE indicator come on? The battery may need to
be charged.
SOUND SIGNALS
A long warbling tone Signals an incoming call
Single Tone A key is pressed
Three short beeps Error tone
Two long beeps Confirmation tone
One short beep and one long beep Page signal
Two short beeps every 15 seconds Low battery warning
TROUBLESHOOTING