Sanyo CLT-J30 - Manual (Page 21)

21
9. Press the number (0 – 6) or use CID/VOL or to select the
desired animation. The selected animation will be displayed when
the incoming call matches with the number you stored.
10. Press MEM again. “RINGER TONE 1” shows on screen.
11. Press 1-3 or 1-6 depending on the model or use CID/VOL or
to select the desired ringer tone (6 melody ring tones available for
J50/J60 or 3 tones for J30/J40/J40(BK)). The selected ringer
tone will be heard when the incoming call matches with the number
you stored.
12. Press MEM again. “VIP 1YES 2 NO” shows on screen.
13. Press the number (1 – 2) or use CID/VOL or to select the
desired status. Once tagged as VIP, this caller can bypass the DND
feature.
14. Press MEM again to store the number to memory. If you are replacing
a number, “REPLACE MEMO?” shows on screen. Press MEM again
to confirm, or press *TONE/EXIT to return to standby mode.
To view your directory, press MEM and use CID/VOL or or the
number (0-9) to scroll.
Replacing a directory entry with a Caller ID entry
Use the same procedure as for storing Caller ID entries in the directory
Changing a stored number
Use the same procedure as for storing a number in the directory
Making calls from the directory
1. Make sure the phone is ON by pressing TALK/CALL BACK.
2. Press MEM.
3. Press the number (0 - 9) for the desired memory location. The
number dials automatically.
Or:
1. Make sure the phone is OFF (not in TALK mode).
2. Press MEM.
3. Press the number (0-9) or use CID/VOL or to select the
desired number.
4. Press TALK/CALL BACK, the number will be dialed automatically.
DIRECTORY