Sanyo CLT-J30 - Manual (Page 18)

18
1. Use the CID/VOL or key to select desired Caller ID entry.
2. Press MEM key, “MEMO # --” shows on the top right corner of
screen.
3. Select the desired memory location by pressing the number keys (0-
9). “ANIMATION 0” shows on screen. “0” means the animation
feature is disabled.
4. Press the number (0-6) or use CID/VOL or to select the
desired animation. The selected animation will be displayed when
the incoming call matches with the number you stored.
5. Press MEM again. “RINGER TONE 1” shows on screen.
6. Press 1-3 or 1-6 depending on the model or use CID/VOL or
to select the desired ringer tone (6 melody ring tones available for
J50/J60 or 3 tones for J30/J40/J40(BK)). The selected ringer
tone will be heard when the incoming call matches with the number
you stored.
7. Press MEM again. “VIP 1YES 2 NO” shows on screen.
8. Press the number (1-2) or use CID/VOL or to select the
desired status. Once tagged as VIP, this caller can bypass the DND
feature.
9. Press MEM again to store the number to memory. If the memory
location already contains name and number information, “REPLACE
MEMO?” will show on screen. Press MEM again if you want to
replace the information and save. Press *TONE/EXIT button to
return the unit to standby mode without saving.
10. If the selected memory location is empty, you will hear a confirmation
tone when the new memory record is saved.
Note: If the selected CID record contains non-digit characters, or the
number is more than 24 digits, the unit will not store the record.
Dialing a Caller ID number
1. Make sure the phone is OFF (not in TALK mode).
2. Use CID or to scroll to the desire Caller ID entry.
3. Use MUTE/FORMAT key to display the phone number in proper
digits if necessary.
4. Press TALK/CALL BACK. The number dials automatically.
CALLER ID FEATURES