Sanyo CLT-J30 - Manual (Page 14)

14
Pre-dialing (up to 32 digits)
1. Make sure the phone is OFF (not in TALK mode).
2. Enter the telephone number. The number is displayed as you enter it.
3. Press TALK/CALL BACK.
Note: Pressing *TONE will exit pre-dialing.
Changing the pre-dial number
1. Make sure the phone is OFF (not in TALK mode).
2. Enter the telephone number.
3. Press CH/DEL to delete digits one by one.
4. Re-enter the number.
Redialing
1. Make sure the phone is OFF (not in TALK mode).
2. Press TALK/CALL BACK.
3. Press REDIAL to redial the last number (up to 32 digits).
Fast redialing
1. Press TALK/CALL BACK.
2. Enter the telephone number you want to dial.
3. If the line is busy, press REDIAL. The phone will drop the line for
two seconds and redial again.
FLASH key
Use the FLASH/PROG key to activate custom calling services such as
Call Waiting or Call Transfer (available through your local phone
company).
Tip: Do not use TALK/CALL BACK to activate custom calling services
such as Call Waiting, or you will hang up the phone.
CH (Channel)/DEL key
While talking, you might need to manually change the channel to get rid
of static. Press the CH/DEL key to switch to a clear channel.
* TONE key
This feature enables Pulse service phone users to access touch-tone
services offered by banks, credit card companies, etc.
1. Call the bank’s information line.
2. Press *TONE after your call is answered.
3. Follow the voice instructions to complete your transaction.
4. Hang up when finished. The phone returns to Pulse service.
BASICS