Sanyo CLT-J30 - Manual (Page 26)

26
LCD SCREEN MESSAGES
The following indicators show the status of a message or of the phone.
BLOCKED NUMBER/
NAME/CALLER
DND
EMPTY
ERROR
ENTER NAME
ENTER TEL NUMBR
DELETE ALL?
DELETE?
END OF LIST
INCOMPLETE DATA
MESSAGE WAITING
NEW
NO CALLS
NO DATA
REPT
UNKNOWN NUMBER/
NAME/CALLER
PAGING
VIP
RINGER=OFF
The person is calling from a number that has
been blocked from transmission.
Do Not Disturb is activated.
There is no record stored to the selected
directory location.
Caller information has been interrupted during
transmission or the phone is excessively noisy.
Prompt telling you to enter name in directory.
Prompt to enter the telephone number for
directory.
Prompt asking you if you want to erase all
Caller ID information.
Prompt asking you if you want to erase the
current Caller ID entry or a directory entry that
is shown on screen.
Indicates that there is no additional information
in Caller ID list.
The telephone provider did not send all Caller
ID information because the signal was weak or
the call was interrupted.
Caller has left a message (you must subscribe
to voice mail service offered by your local
phone company for this to work).
Indicates call or calls have not been reviewed.
There are no Caller ID records stored to
memory.
No Caller ID information was received.
Repeat call.
The incoming call is from an area not serviced
by Caller ID, or the information was not sent.
Someone has pressed the PAGE key on the
base.
Caller has been marked as a Very Important
Person in directory.
Ringer ON/OFF switch on the right side is set
to OFF.