Staber Industries HXW2305 User Manual
Page 10
10
REPLACE DRIVE BELT
1
Remove the front panel as directed under "REMOVE FRONT PANEL".
2
Remove belt and inspect pulleys for wear and tightness.
3
Install new belt on pulleys, check belt tension and adjust as necessary.
Install front panel on clothes washer as directed under "INSTALL
FRONT PANEL" and plug power cord into electrical receptacle.
REPLACE PUMP
1
Remove the front panel as directed under "REMOVE FRONT PANEL".
2
Remove sump and drain hoses from pump (with pliers) using a pan to
catch any trapped water.
3
Remove wires from pump.
4
Remove two bolts from pump and remove pump from clothes
washer.
5
Install wires on new pump, install pump on clothes washer, reconnect
sump and drain hoses on pump and reinstall front panel as directed
under "INSTALL FRONT PANEL". Plug power cord into electrical
receptacle.
REPLACE DRIVE MOTOR
1
Remove the front panel as directed under "REMOVE FRONT PANEL".
2
Remove belt adjustment bolt and drive belt from motor.
3
Remove clip and washer from pivot shaft. Slide shaft to rear far enough
to allow motor to come off shaft.
4
Note position of wiring plugs on motor and remove plugs from motor.
5
Install wiring plugs on new motor as noted, position motor on shaft, slide
shaft into position and secure with washer and clip. Install drive belt
adjustment bolt on motor. Install drive belt, adjust belt tension and
tighten adjustment bolt. Install front panel on clothes washer as directed
under "INSTALL FRONT PANEL" and plug power cord into electrical receptacle.
REPLACE TIMER
1
Disconnect the appliance from the power source.
2
Remove the six screws that hold the control panel to the top.
3
Allow the control panel to slide down, pull the top of the control panel out
and lift up.
4
Lay the control panel face down on the top while removing the timer.
5
To release the setting knob pull out on the black shaft extending through the
timer. Pull off indicator dial.
6
Remove the timer wire harness connection. Lift up locking tap and pull out
on the harness until the connector is free from the timer.
7
Note the position of the timer. The replacement will be reinstalled in the
same position.
8
Remove the 5/16 headed screw that holds the timer to the control panel.
9
Lift up on timer locking tap labeled "1" and slide the complete timer to
the left and remove. Install the new timer in reverse sequence.
10 Install timer mounting screw.
11 Reinstall the wire connection. Once the timer connection is fully seated,
you will hear a slight click. This indicates that the locking tab is locked.
12 Replace the timer indicator dial. There is a flat on the inside of the
indicator that will match the flat on the timer plastic shaft. This will
align the indicator dial on the timer.
13 Install knob on timer and push black shaft extending through timer
until flush with rear of timer housing.
Replpump R1
PUMP
SUMP HOSE
DRAIN HOSE