Staber Industries HXW2305 - Manual (Page 8)

8
CONTROLS
Temperature Controls temperature of wash water only. Clothes washer is
designed to use cold water for rinses.
Water level Controls amount of water entering clothes washer during
each fill. Use High setting for all normal loads containing a fully or loosely
packed tub. Use Low setting for loads containing only a few garments.
Wash cycle Controls agitation speed, agitation duty cycle and spin speed.
Use Normal setting for most fabrics; it has the fastest spin speed. Perm
and Delicate settings have the slower spin speeds. Use Perm setting for
cottons and blends with a No-Iron fabric. Use Delicate setting for delicate
and knit items.
Timer Controls selection of pre-wash cycle and length of wash cycle.
Power lamp ON indicates that power is being applied to electronics to
start clothes washer.
Lid locked lamp ON indicates that lid lock has locked and spin cycle can
begin. OFF indicates that lid lock has released and top lid may be safely
opened. DO NOT attempt to open lid while this lamp is ON.
LIQUID DISPENSING SYSTEM
All holding reservoirs will retain a maximum of 2 ounces of liquid solution.
Flow through reservoir serves as a funnel to dispense a pre-measured
amount of low sudsing liquid detergent or bleach into wash tub without
pouring solution directly onto clothes in tub.
Recommended amount of low sudsing liquid detergent, bleach, or fabric
softener to use for normal wash loads is 1 ounce. For Low water level
setting, use 1/2 ounce.
Use a water-like concentration liquid fabric softener. Using a thick
concentrate softener can clog reservoir outlet. If clogging occurs, flush
reservoir with clean water.
OPERATION
PR ES S H ER E
LEFT HAND HERE
RIGHT HAND HERE
BLEACH
SOFTENER
USE BOTH HANDS TO OPEN & CLOSE TUB
USE LIQUID ONL Y
DETERGENT
DISPENSER