Staber Industries HXW2305 - Manual (Page 5)

5
CAUTION: Use great care when loading, unloading or working around
clothes basket with top lid raised. DO NOT allow any items to fall between
inner and outer tubs. If this should occur DO NOT START WASHER. The
item must be removed from the tub or damage to the clothes basket or
water system may occur. If the item cannot be removed by rotating the
clothes basket, we recommend removing the item though the sump hose.
Refer to maintenance procedures for details.
Uncrate clothes washer using care not to scratch or damage surface of washer.
IMPORTANT: When lifting or moving clothes washer, always do so from
left and/or right side of washer. Lifting or moving from the front or back
may damage clothes washer.
Lift clothes washer straight up off bottom of shipping container and
remove styrofoam shipping block. Unpack clothes basket and accessories.
NOTE: We recommend that all shipping materials be either retained for
later use in moving the clothes washer or recycled through a local solid
waste management agency.
The water fill hoses are pre-attached to the water inlet valve on the rear of
the washer and should not be removed during installation.
Place clothes washer in position taking care to move clothes washer by
moving only from either side.
Level clothes washer side-to-side and front-to-back. DO NOT level washer
with front higher than back, damage to internal parts can result.
Place a bubble level on top of clothes washer with lid open. Loosen
locknuts on leveling legs and level washer. Keep leveling legs as close to
washer frame as possible.There should be an equal amount of weight on
all four legs.
After washer is level, secure legs by rotating locknuts up against washer
frame. Locate the four foot pads and install one on each leveling leg.
Recheck level of clothes washer and adjust as necessary.
Remove all but the lowest drain hose shipping ties from back of washer.
Form a 'gooseneck' in free end of hose, place end in standpipe and secure.
Attach free end of each fill hose to appropriate water supply, top hose to
hot water supply and bottom hose to cold water supply. Turn water on
and check for leaks.
Plug power supply cord into grounded 120V60Hz electrical receptacle only.
WARNING: Do not use adapter plug, extension cord, or remove
grounding prong from power supply cord. Do not modify plug provided
with this clothes washer. If it will not fit a properly grounded outlet, have a
properly grounded outlet installed by a qualified electrician. Electrical
current can cause fire and serious bodily harm.
INSTALLATION
Grounding type
wall receptacle