Staber Industries HXW2305 - Manual (Page 12)

12
REPLACE PRESSURE SWITCH
1
Disconnect the appliance from the power source.
2 Remove the six philips head screws that hold the control panel to the top.
3 Allow the control panel to slide down, pull the top of the control panel
out and lift up.
4 Lay the control panel face down on the top.
5 Pull up on the pressure switch that is fastened to the bottom of the
control housing.
6 Remove the connectors from the switch.
7 To install a new switch, reverse the above procedures.
8 Plug power cord into electrical receptacle.
REPLACE WATER VALVE
1
Disconnect the appliance from the power source.
2 Shut off the hot and cold water supply.
3 Remove the six screws that hold the control panel to the top.
4 Allow the control panel to slide down, pull the top of the control panel
out and lift up.
5 Lay the control panel face down on the top.
6 Using a 5/16 nut driver, remove the water valve hold down nut
located between the two electrical coils on the valve. Lift the water
valve from the control panel.
7 Note on a piece of paper, position and color of electrical wires on the
water valve. Remove the wires from the valve.
8 Remove the two inlet hoses from the water valve.
9 Remove the outlet hose from the water valve.
10 Install a the new water valve on the clothes washer by reversing the
above procedures.
11 Turn on both water supplies. Check for water leaks.
12 Plug the power cord into electrical receptacle.
REPLACE LID LOCK SWITCH
1
Remove the front panel as directed under "REMOVE FRONT PANEL".
2 Remove two screws from lid lock switch bracket and remove switch
from clothes washer.
3 Note on a piece of paper, position of wiring plug on switch. Remove
plug from switch.
4 Install plug on new switch as noted and install switch on clothes
washer. Reinstall front cover as directed under "INSTALL FRONT PANEL"
and plug power cord into electrical receptacle.