Staber Industries HXW2305 - Manual (Page 14)

14 TROUBLESHOOTING
PROBLEM
Water does not drain from clothes washer.
Washer does not spin
Washer walks across floor.
Washer spins with a full tub of water.
Water leaks from washer.
Timer does not advance in prewash, wash
or rinse cycles.
CAUSE
Obstruction in sump area of outer tub.
Obstruction in sump hose.
Obstruction in pump.
Obstruction in drain hose or stand pipe.
Pump has failed.
Stand pipe higher than seven feet.
Poor connection on timer plug.
Motor control circuit has failed.
Pressure switch has failed.
Drive belt has broken or come off the pulley.
Motor has failed.
Out of balance switch has tripped.
Program selector switch has failed.
Pump did not pump out water.
Shipping block under motor not removed.
Washer not level.
Weight of washer not evenly distributed on
all four leveling legs.
Out of balance switch out of adjustment.
Defective control board.
Reverse polarity at receptacle.
Defective pressure switch.
Over sudsing of wash load.
Rubber skirt not in correct position.
Defective hose from water valve to soap
dispenser.
Defective drain hose.
Sump hose hanger not on
Not enough water.
CORRECTIVE ACTION
Remove obstruction.
Remove obstruction.
Remove pump and clear obstruction.
Remove obstruction.
Replace pump.
Shorten stand pipe.
Reseat connector.
Check circuit breaker on back of machine.
If showing white is has popped out and will
push gently- do not force.
Replace pressure switch.
Replace belt or reinstall drive belt.
Replace motor.
Wash a larger load.
Replace program selector switch.
Remove obstruction from pump.
Remove shipping block.
Level washer.
Adjust leveling legs properly.
Adjust out of balance switch.
Replace control board.
Call electrician and correct.
Change pressure switch.
Reduce amount of detergent. Do not use
Ultra products.
Reseat skirt into outer bezel.
Replace hose.
Replace drain hose and install in correct position.
Reinstall sump hose hanger
Check water supply.
Check inlet screens at water valve.
Replace water valve.