Staber Industries HXW2305 - Manual (Page 9)

9 MAINTENANCE PROCEDURES
REMOVE FRONT PANEL
1
Disconnect the appliance from the power source.
2 Remove the four 5/16 headed screws located at the bottom of the front panel.
3 After the screws have been removed, grasp the panel on both sides
and pull forward.
Allow the panel to drop free of the top assembly and set aside.
INSTALL FRONT PANEL
1
Locate left and right side of front panel over guide pins on cabinet.
2 While applying upward pressure, use a 5/16 nut driver and screw the
four 5/16 headed screws back in the bottom of the front panel.
HOW TO RAISE TOP ASSEMBLY
1
Remove front panel.
2 Remove the two 5/16-headed screws located at the upper left and
right corner of the edge of the cabinet. These two screws will allow
access to the interior of the machine. Set these two screws aside
separate from the other four screws because they may be different on
your machine.
3 Lift up on the front of the top until the two front clips have cleared the
edge of the cabinet. Note: Secure the lid to the top panel with a piece
of tape or some other means. Once the top is raised vertically, the lid
might open and fall backwards. This could damage the lid or cause it
to become detached from the top.
4 Pull the plastic top assembly towards you an inch to free up the
hinges on the back. Then lift the top until you can gain access to the
rear wall of the cabinet. Note: Again, secure the top so it will remain
open while you are working in this area. If the top is not secured, it
could fall closed while you are working in this area.
ACCESSING THE MOTOR CONTROL BOARD
1
First unplug the machine from its power source.
2 Remove front panel
3 Raise top assembly
4 The motor control board is now accessible. The location of the board
is on the rear upper right corner of the cabinet.