Staber Industries HXW2305 User Manual
Page 11
11
14 Reinstall control panel to housing. Insert bottom of control panel into
housing first. Then slide the panel into place and secure with six
philips head screws.
NOTE: Do not over tighten the screws or you will strip the holes and
the screws will not hold.
15 Plug machine into the 120 vac power supply.
REPLACE TEMPERATURE, WATER LEVEL AND WASH CYCLE SWITCHES
1
Disconnect the appliance from the power source.
2
Remove the six screws that hold the control panel to the top.
3
Allow the control panel to slide down, pull the top of the control panel
out and lift up.
4
Lay the control panel face down on the top.
5
Pull knob off switch to be replaced. Unscrew attaching nut from
switch and remove switch from front control panel. Note on a piece of
paper, position and color of electrical wires on switch. Remove wires
from switch.
6
Install wires on new switch as noted. Install switch on control panel
using nut. Reinstall control panel by reversing procedures above.
Install knob on switch and plug in power cord.