Smeg DRY63CS - Manual (Page 24)

129530
129530
Interferences from the ambient (for example
electrical wiring) could induce signalization of
different faults. In such cases:
- switch the appliance off, and wait for a few
seconds;
- switch the appliance back on and repeat the
washing program.
If the fault repeats, call authorized service shop.
24 25
Troubles
Trouble Check
Appliance does not
work:
• If there is current in the socket and if the fuse is
functioning.
• If the plug is correctly inserted into the socket.
There is current in
the socket, but the
drum is not rolling:
• If the door is closed tightly (press it towards the
appliance).
• If the program runs according to instructions.
• If the container is full (only with condensation
dryer).
• If appropriate drying time is selected.
Laundry is not dry: • If the filter is clean.
• If the condensation device is clean (only with
condensation dryer).
• If the room is adequately ventilated.
• If the amount of laundry to be dried is not too big.
• If the evacuation tube is too long (only with
evacuation dryer - max 2 m).
• If the laundry loaded in the drum has not been
spun enough or if appropriate drying time has
been set.
• If the room is too hot (over 25°C, applies for
condensation dryer).
The condensation is
inadequate:
• If the room temperature is too high.
• If the condensation device is clean.
Unevenly dried
laundry:
• If the amount of laundry to be dried is not too big.
• If there are only large pieces of laundry (large and
small pieces should be dried together).
• If different fabrics are dried together (group the
laundry according to the type of fabrics).