Sharp AR-C250 - Manual (Page 11)

9
ACCOUNT CONTROL
The programs of this category are used to set the internal auditor
functions. These programs can be selected by pressing the “ACCOUNT
CONTROL” key and then selecting the desired program key.
Auditing Mode
This program is used to enable or disable the basic auditing mode.
The auditing mode can be set for both the color and black/white (B/
W) copy modes and for only the color copy mode.
When the auditing mode is disabled, the message in the display will
be “
READY TO COPY. ” Access to copying is open to any operator.
When the auditing mode has been set for both the color and B/W
copy modes, the message in the display will be “
ENTER YOUR
ACCOUNT NUMBER. ----- ”. Copying in this state is limited to
operators with an assigned 5-digit account number.
If the auditing mode has been set for only the color copy mode, B/W
copying is open to any operator but color copying is limited to
operators with an assigned 5-digit account number. When the AUDIT
key or the COLOR COPY START (
) key is pressed, the
message “ ENTER YOUR ACCOUNT NUMBER FOR COLOR
COPYING. ----- ” will appear.
A maximum of 400, 5-digit account numbers can be assigned. Use
key operator program “Account Number Control” (page 13) to assign
account numbers.
When the “AUDITING MODE” key is pressed, the following display
will appear.
1. Select the desired auditing mode or select “DISABLE”
to disable the auditing mode that has been set.
2. Press the “OK” key to exit the program.
KEY OPERATOR PROGRAMS
KEY OPERATOR PROGRAMS
AUDITING MODE OK
COLOR & B/W
COLOR ONLY
DISABLE