Sharp AR-C250 - Manual (Page 30)

28
Disabling of Bypass-Tray in Duplex Copy
This program is used to disable the use of the bypass tray when making
duplex copies.
To disable use of the bypass tray when making duplex
copies, press the check box of “DISABLING OF BYPASS-
TRAY IN DUPLEX COPY” to display a check mark in the
check box.
To restore use of the bypass tray, press the check box of this
program again to clear the check mark in the check box.
Disabling Deletion of Job Programs
This program is used to prevent stored programs from being replaced
or deleted. If this program is set, storing of job programs is also
disabled.
To prevent job programs stored in memory from being
replaced or deleted, press the check box of “DISABLING
DELETION OF JOB PROGRAMS” to display a check mark in
the check box.
To allow replacement/deletion, press the check box of this
program again to clear the check mark in the check box.
Disabling of Document Feeder
This program is used to prevent the use of the optional document
feeder when it malfunctions.
To prohibit use of the document feeder, press the check box
of “DISABLING OF DOCUMENT FEEDER” to display a check
mark in the check box.
To enable use of the document feeder, press the check box
of this program again to clear the check mark in the check
box.
Disabling of Duplex Copying
This program is used to enable or disable the optional duplex system.
If a malfunction occurs within the duplex system of the copier, the
system can be disabled until it is serviced. The rest of the copier in the
meantime will remain operable.
KEY OPERATOR PROGRAMS