Sharp AR-C250 - Manual (Page 28)

26
KEY OPERATOR PROGRAMS
Preheat Mode Setting
Preheat mode functions to control the power consumption by lowering
the temperature of the fusing unit to a programmed level once a
programmed length of time has elapsed without any copier operation
after the last copy of a run is made or power is turned on. This function
lowers user’s electricity bill, reduces waste of natural resources, and
cuts down on environmental pollution. The programmed time is set to
15 minutes for this function on completion of shipment from the factory.
The default time can be changed optionally within the prescribed range
of time. We suggest you set the most appropriate time according to
your usage pattern.
This program is used to set the time that elapses before the copier
enters the preheat mode after copying is completed. The interval can
be set between 10 and 240 minutes in 1 minute increments.
When the “PREHEAT MODE SETTING” key is pressed, the following
display will appear.
1. Set the desired time interval using the and keys.
2. Press the “OK” key.
Message Time Setting
This program is used to adjust the length of time that messages are
displayed in the range of 1 to 12 seconds in 1 second increments.
When the “MESSAGE TIME SETTING” key is pressed, the following
display will appear.
1. Set the time using the and keys.
2. Press the “OK” key.
KEY OPERATOR PROGRAMS
PREHEAT MODE SETTING
SET THE TIME FOR PREHEAT MODE.
15
(10~240)
min.
OK
TIME:
KEY OPERATOR PROGRAMS
MESSAGE TIME SETTING
SET THE TIME FOR MESSAGES.
6
(1~12)
sec.
OK
TIME: