Sharp AR-C250 - Manual (Page 22)

20
Initial Margin Shift Setting
Set the initial margin shift value with this program.
When the “INITIAL MARGIN SHIFT SETTING” key is pressed, the
following display will appear.
1. Adjust the value for each side using the and
keys.
● The value can be set from 0" to 1" in 1/8" increments.
● If an optional duplex module (AR-DU2) is not installed, the value
for the reverse side (side 2) is not displayed.
2. Press the “OK” key.
Erase Width Adjustment
Set the initial setting of the amount of the erase area with this program.
When the “ERASE WIDTH ADJUSTMENT” key is pressed, the
following display will appear.
1. Adjust the values for the edge erase and the center
erase respectively using the
and keys.
● The values can be set from 0" to 1" in 1/8" increments.
2. Press the “OK” key.
KEY OPERATOR PROGRAMS
OK
KEY OPERATOR PROGRAMS
INITIAL MARGIN SHIFT
SETTING
SET THE INITIAL MARGIN SHIFT.
SIDE 1
(0~1)
inch
SIDE 2
(0~1)
inch 1/2 1/2
OK
KEY OPERATOR PROGRAMS
ERASE WIDTH ADJUSTMENT
SET THE INITIAL ERASE WIDTH.
(0~1)
inch
OK
1/2