Southbend SB1001 - Manual (Page 55)

For Machines Mfg. Since 8/11 Model SB1001 8K ™ Lathe
-53-
S E R V I C E
The lathe must be properly prepared if it will be
stored for any period of time. Doing this will help
prevent the development of rust and corrosion.
and ensure the lathe remains in good condition
for later use.
To prepare the lathe for storage:
1. DISCONNECT LATHE FROM POWER!
2. Thoroughly clean all surfaces, then apply a
heavy coat of way oil to unpainted and bare
metal surfaces.
3. Lubricate the machine as outlined in
Lubrication, beginning on Page 51, then
move/rotate the components through the full
range of motion several times to distribute
the lubricant.
4. Cover the lathe and place it in a dry area
that is out of direct sunlight and away from
hazardous fumes, paint, solvents, or gas that
could damage the surfaces of the lathe.
5. Once or twice a month, move the carriage,
tailstock, and other components mounted on
the bedway down the bed to make sure that
rust is not beginning to occur. If it is, remove
it and re-apply a heavy coat of way oil.
6. Every few months, repeat Step 3.
Machine Storage
After a long period of time, you may find that
the leadscrew develops a small amount of end
play. This end play can be removed with an
adjustment of the lock collars on the right end of
the leadscrew.
Tools Needed: Qty
Hex Wrench 2.5mm ..............................................1
To remove leadscrew end play:
1. DISCONNECT LATHE FROM POWER!
2. Insert the hex wrench or similar tool into a
hole on the rim of the outside leadscrew lock
collar (see Figure 88) to loosen it a couple of
turns.
Leadscrew End Play
Adjustment
Figure 88. Longitudinal leadscrew lock collars.
Outside
Lock
Collar
Inside
Lock
Collar
3. In the same manner, loosen the inside lock
collar a couple of turns.
4. Engage the half nut with the leadscrew,
then use the handwheel to move the carriage
toward the tailstock with slight pressure.
5. Tighten the inside lock collar until it is just
snug, then tighten the outside collar against
it to secure the setting.