Socket Mobile Series 9 - Manual (Page 21)

Your mobile device cannot connect to the CRS if another device is set as
the default Bluetooth serial device.
If Connect CS does not appear, tap Settings in the menu, tap on the CS
tab, and enable cordless scanner support.
6. Your device will begin searching for the CRS.
• If you installed Connect!Agent, your mobile device will automatically
search for and connect to the CRS. A beep will indicate the
connection.
• If you did not install Connect!Agent, your device’s Bluetooth
software will search for devices. In the list of found Bluetooth
devices, select Socket CRS. The device will connect to the CRS,
indicated by a beep.
The six characters following the device name are the last six
characters of the Bluetooth MAC address.
If using the Broadcom (Widcomm) stack, you will be prompted to
configure automatic connections.
If a passkey is requested, enter 1234.
7. After your mobile device connects to the CRS, the SocketScan icon at the
bottom of the Today screen will change into a ring icon to indicate the
connection.
Connect!Agent will save information about the CRS to automate future
connections to your specific unit.
CHAPTER 3: SETUP FOR WINDOWS MOBILE 21