Savin 2027 - Manual (Page 29)

25
4. Troubleshooting
Error & Status Messages on the Display
Panel
This section describes the principal messages that appear on the panel display.
If a message not described here appears, act according to the message.
Reference
Before turning the main power off, see ‘Turning On the Power’, General Set-
tings Guide.
❖ ❖ ❖ ❖ Status messages
❖ ❖ ❖ ❖ Alert messages
Message Status
Hex Dump Mode In Hex Dump mode, the machine receives data in hexadecimal
format. Turn off the machine after printing, and then turn back
on.
Offline The machine is offline. To start printing, switch the machine
online by pressing [Offline] on the display panel.
Please wait. The machine is preparing the development unit. Wait a while.
Printing... The machine is printing. Wait a while.
Ready This is the default ready message. The machine is ready for
use. No action is required.
Resetting job... The machine is resetting the print job. Wait until “Ready” ap-
pears on the display panel.
Waiting... The machine is waiting for the next data to print. Wait a while.
Messages/Second messages Causes Solutions
Cannot connect with the
wireless card. The IEEE 802.11b card may
have come off, or an error may
have occurred in the IEEE
802.11b card. Turn off the main power
switch, and check the card is
installed correctly. If the mes-
sage appears again, contact
your sales or service repre-
sentative.
Close duplex unit cover. The cover of the duplex unit is
open. Close the cover of the duplex
unit.
Collate has been cancelled. The collate print function has
been canceled. Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.