Savin 2027 - Manual (Page 32)

Troubleshooting
28
4
NV-RAM has a problem. An error has occurred in the
optional memory unit. Turn off the main power
switch, and back on again. If
the message appears again,
call your sales or service repre-
sentative.
Output tray has been
changed. The output tray has been
changed because of the paper
size limitation of the selected
tray. Select the correct output tray.
Paper in duplex unit. Open
cover and remove paper. There is a misfeed in the du-
plex unit. Open the cover of the duplex
unit, and remove the misfed
paper.
Paper in staple tray. Open fin-
isher cover and remove pa-
per. There is paper remaining in-
side the finisher. Open the cover of the finisher,
and remove the paper.
Parallel I/F board has a prob-
lem. An error has occurred in the
parallel interface board. Contact your sales or service
representative.
Print overrun. The image data has been
thinned out due to image com-
pression. Increase memory capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Problems with the wireless
board. An error may have occurred in
the IEEE 802.11b card (wire-
less LAN board). Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Problems with the wireless
card. An error may have occurred in
the IEEE 802.11b card.
RPCS graphic error. There is insufficient graphics
memory to print the data. Specify the correct memory
capacity on the [Change Acces-
sories...]
option in the RPCS™
printer driver.
To print the image correctly,
install more memory in the
machine, or reduce image res-
olution.
RPCS memory overflow. A memory overflow occurred
during the print job. After part
of the data is printed, the print
job is suspended. To print the image correctly,
install more memory in the
machine, or reduce image res-
olution.
RPCS syntax error. Bidirectional transmission
may not be working properly,
or the RPCS™ printer driver
settings may not be correct. Confirm the option settings
for the printer driver match
the options installed on the
machine.
Messages/Second messages Causes Solutions