Savin 2027 User Manual
Page 31
Error & Status Messages on the Display Panel
27
4
Exceeded max. pages. Collate
is incomplete.
The maximum number of pag-
es has been exceeded for colla-
tion.
Turn off the main power
switch, and back on again. Re-
duce the number of pages to
be printed. If the message ap-
pears again, contact your sales
or service representative.
Finisher is in use for another
function. Please wait.
The finisher is in use by anoth-
er function, such as the copier
function.
Wait until the other function
has finished using the finisher.
Following output tray is full.
### Remove the paper. ###
The indicated output tray is
full.
Note
❒ “###” in the message rep-
resents a output tray.
Remove the paper.
HDD has a problem.
An error has occurred in the
hard disk drive.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
HDD has not been installed.
Locked Print was performed
without the hard disk in-
stalled, or the hard disk is
damaged.
Contact your sales or service
representative.
HDD is full.
The maximum hard disk area
size for form/font has been ex-
ceeded.
Delete unused form /font
types.
An HDD overflow error oc-
curred during Sample Print or
Locked Print.
Delete some stored files, or re-
duce the size of the file to be
downloaded.
IEEE 802.11b (Wireless LAN)
has a problem.
IEEE 802.11b card was not in-
serted when the machine was
turned on, or it was pulled out
after the machine turned on.
Turn off the machine and
check the IEEE 802.11b card is
inserted correctly. Then, turn
the machine on again. If the
message appears again, call
your service center.
LCT has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
An error has occurred in the
Large Capacity Tray (LCT).
Turn off the main power
switch, wait five minutes, and
on again. If the message ap-
pears again, call your sales or
service representative.
dLower Staple is almost
empty.
There are only a few staples
left in the lower stapler.
Load more staples.
Messages/Second messages
Causes
Solutions