Studer Innotec RCC-03 - Manual (Page 14)

Studer Innotec
14
QUICK START GUIDE
The remote control RCC gives you access to a many settings possibilities. However, in most cases
the setting of two parameters is required for the perfect running of your installation.
A
DJUSTMENT OF THE LANGUAGE
To begin, set your remote control RCC for a display of the information in English.
The basic display is:
Press 2 times on the key “arrow downwards” to display the
following screen:
Once beyond this screen you can come back to it by means
of the key ”arrow upwards”.
Press the key SET to enter the remote control settings. The
screen of the language choice appears.
Press once more the key SET to modify the current language.
The language then appears in reverse video.
With the keys “arrow upwards” and “arrow downwards” choose the language you wish. Then
validate your choice by means of the key SET (OK).
We can now leave the setting of the remote control with the key ESC.
A
DAPTATION TO THE SOURCE
It is a matter of indicating to the Xtender the power available to charge the batteries and to supply
the users.
In order to adapt your installation to the source it is connected to, proceed as follows :
The basic display is:
Press 3 times on the key “arrow downwards” to display the
following screen:
Once beyond this screen you can come back to it by means
of the key ”arrow upwards”.
Press the key SET to access to the settings.
Then again on the key SET to access to the basic parameters.