Kenwood HM-381MD - Manual (Page 73)

HM-381MD (En)
73
Knowledge section
Remedy Cause Symptom
CD player section
÷ Place the disc properly, with the label
side facing upward.
÷ Place the disc properly.
÷ Clean the disc referring to “Disc han-
dling precautions”.
÷ Try another disc.
÷ Refer to “Caution on condensation” and
remove the condensation by evaporation.
÷ Place a disc in the CD player.
÷ Press the 6 key.
÷ Clean the disc referring to “Disc han-
dling precautions”.
÷ Try another disc.
÷ Clean the disc referring to “Disc han-
dling precautions”.
÷ Try another disc.
÷ Install the unit in a place not subject to
vibrations.
A CD is placed in the player but
it cannot be played.
Sound is not produced.
Sound skips.
÷ The disc is placed upside down.
÷ The disc position is displaced.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ Dew is condensed on the optics lens.
÷ The disc has not been placed.
÷ The player is not put to the play mode.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ The disc is dirty.
÷ The disc is scratched.
÷ The player is subject to vibration.
8
Ø
8
8
Remote control unit
Symptom Cause Remedy
Remote control operation is
not possible.
÷ Batteries are exhausted.
÷ The remote control is too far away from
the system, the controlling angle is devi-
ated or there is an obstacle in between.
÷ The component to be played is not loaded
with a CD, MD or cassette tape.
÷ Replace with new batteries.
÷ Operate the unit inside the remote con-
trollable range.
÷ Load a CD, MD or cassette tape in the
component to be played.
&
&
In case of difficulty