Kenwood C-707I - Manual (Page 72)

C-707I 72
Setting the Timer
C-707I
Select “PLAY” or “AI PLAY”.
Press the [<] or [>] key.
8 8
Set the volume.
Press the [<] or [>] key.
9 9
Press the [ENTER] key.
Select the input source.
Press the [<] or [>] key.
The mode setting cycles as shown below each time you press a key.
10 10
If you selected an input source other than “TUNER”, this completes the setting
procedure. The message “COMPLETE” will appear on the display briefl y,
followed by the normal display.
If you selected “TUNER”, use the [<] and [>] keys to select a preset number,
and then press the [ENTER] key. This completes the setting procedure.
“COMPLETE” will appear on the display briefl y, followed by the normal display.
Playback is at the volume you set in step 9.
You cannot use the [VOLUME] key to set the volume.
Specify the “OFF TIME” (off time).
7 7
Press the [ENTER] key.
Press the [ENTER] key.
Use the [<] and [>] keys to set the hour.
Use the [<] and [>] keys to set the minutes.
This setting causes the volume to increase
gradually up to the volume level you set in
step 9.
Press the [ENTER] key.
AUX D.AUDIO
TUNER CD iPod
USB
Press the [ENTER] key.
en10_c-707i.indd 72 en10_c-707i.indd 72 12/27/2007 10:26:21 AM 12/27/2007 10:26:21 AM