Kenwood C-707I - Manual (Page 81)

81 English
Symptoms Solution Ref. page
Device connected to the [iPod] terminal
iPod is not recognized. Connect with a PNC-iP120 iPod connection cable
(optional accessory).
Connect the PNC-iP120 iPod connection cable
securely.
Check that the iPod model is compatible for playback
by the system. 17
17
27
Cannot control the iPod. Disconnect the iPod from the system, disconnect all
devices from the iPod, and then re-connect it to the
system.
Check that the iPod model is compatible for playback
by the system. 17
27
Poor response. iPod response becomes poor when there is a large
number of tracks on the iPod. This is particularly true
when shuffl
e is turned on for a large number of tracks,
which can cause poor response of the iPod itself.
27
Symptoms Solution Ref. page
Remote control
The remote control
does not work. Load new batteries.
Use the remote control within its eff ective range. 21
21
Troubleshooting
Symptoms Solution
Resetting the microcomputer
Microcomputer
malfunction (the system
does not work, the
display is faulty, etc.). Reset Procedure (Main unit only)
1 Turn off the power (press the [K] key to enter Standby mode).
2 While holding down the [H] and [STOPF] keys on the main unit, hold
down the main unit's power [ K] key until the message “CLEAR ALL” appears
on the display.
Remember that resetting erases any stored information and restores the
system's default settings.
en12_c-707i.indd 81 en12_c-707i.indd 81 1/10/2008 9:49:39 AM 1/10/2008 9:49:39 AM