Kenwood HM-582MD User Manual
Page 72
72
Timer operation
Preparation section
Basic section
Application section
Knowledge section
÷ To listen to CD
Program timer playback (AI timer playback) and timer recording
Two timer programs (PROG.1, PROG.2) are available. Both of them are 24-hour timer programs which can be
executed every day.
Each of timer reservation programs PROG.1 and PROG.2 can store the time zone and contents of timer operation,
which can be executed or deactivated as required.
1
Select the source to be played (recorded) and adjust its playback volume.
The station should be preset prior.
§¶•
Insert a CD
(Program playback is not possible.)
)
2
Select the timer reservation mode.
÷ If you make a mistake in the middle, press the menu/demo
key to cancel the operation and restart it from step
2.
÷ When a timer reservation already has been made, the con-
tents will change to the new settings.
Make preparations for recording.
¤‹ Steps 1 to 3
÷ To listen to MD
÷ For recording
Insert a MD
(Program playback is not possible.)
£
÷ To listen to radio
÷ It is possible to execute both timer reservation programs PROG.1 and PROG.2 simultaneously.
÷ The time zones of PROG.1 and PROG.2 should be set by reserving an interval of 1 minute or more so that they are not overlapped.
1 Press the menu/demo key.
2 Timer setting selection
Blinks
Blinks
Example for playing radio broadcast from 10:30am to
11:30am using PROG.1
÷ Recording or playing the AUX
source component
For timer playback or timer record-
ing of a source component con-
nected to the AUX jacks, connect it
properly by referring to “Connec-
tion of Other Accessories ”.
9
3 PROG.1 selection
volume/
multi-control
\
\
s
e
t
Be sure to adjust the clock before setting the timer.
%
T
IMER
S
ET
?
T
IMER
S
ET
PROG.1
?
TONE
PROG
1
12 30PM
2 Rotate the volume/multi-control knob to
select “TIMER SET ?” , then press the set
key.
3 Rotate the volume/multi-control knob to
select “PROG.1 ?”, then press the set key.
÷ In case an associated system compo-
nent is connected, also read the instruc-
tion manual of the component.