Advanced) security levels and passwords – KMC FLEXSTATTM BAC-10000 User Manual
Page 9
BAC-10000 Series
9
Operation Guide, Rev. J
(Advanced) Security Levels and Passwords
SECURITY
ACCESS LEVELS
PASSWORDS
ACCESS LEVELS
SETPOINT ADJ:
MAIN MENU: ADMIN
SYSTEM MODE: OPER
OCC OVERRIDE: USER
FAN OCC/UNOCC: OPER
NONE
PASSWORDS
USER:
OPERATOR:
ADMIN:
1 0 0 0
1 2 3 4
5 6 7 8
Access to the Main Menu, Setpoint Adjust, and
System/Occupancy/Fan settings have a default
password level of User. This level can be changed for
each function to None, Operator, or Administrator
through the Access Levels menu. Passwords are set
in the Passwords menu.
Any person can view the display but might not be
able to change any settings without logging in with
one of the three levels of passwords:
• None (Level “0”): No password is required
(everyone has access).
• User (Level 1): See the Menu Items Access Levels
chart.
• Operator (Level 2): See the Menu Items Access
Levels chart.
• Administrator (Level 3): Can access all menus
and change all editable values. DO NOT
FORGET THIS PASSWORD!
NOTE: Setting a password to (the default) 0000
eliminates the password prompt and
allows full access for that level. If no
password is set for ADMIN, no password
prompt will occur. If any password is set
for ADMIN, the menu items accessible
at the various levels are shown in the
following chart.
NOTE: Changes in security levels and/or
passwords take effect when the current
Administrator log-in has timed out. Log-
ins last until 60 seconds (default) after
the last button press. Desired length of
inactivity time-out can be changed in the
Systems submenu.
NOTE: When setting a password, the Up button
increases the alphanumeric value (0
through 9 and then A through Z). The
Down button decreases the value. DO NOT
FORGET THE ADMIN PASSWORD!
To enter an alphanumeric password at the prompt:
1. Up/Down to move.
2. Enter to select.
3. Up/Down to increment/decrement value.
The required password level is specified in the
prompt.
For additional security and protection from
vandalism, install the FlexStat inside a third-party
locking thermostat guard/cover (but proper airflow
must be maintained).
Menu Items Access Levels
Menus
User Operator Administrator
Home Screen
* = Selectable, Default is User
Setpoint Adjust (Up/Down)
x*
x*
x*
System Mode (Auto/Heat/Cool/Off)
x*
x*
x*
Occupancy Override (On/Off)
x*
x*
x*
Fan Modes (Auto/On/Off)
x*
x*
x*
Main Menu* (Default is User)
About
x
x
x
Advanced
x
x
Alarm
x
x
Date/Time
x
x
Schedule
x
x
Setpoints
x
x
System
x
x
Trend Viewer
x
x
x
Advanced Menu
Application
x
Additional Setup
x
Control Basic Programs
x
x
Communication
x
Date/Time
x
x
Device
x
Inputs
x
x
Limits
x
x
Motion Sensor
x
x
Security
x
Trend Logs
x
x
Test
x
x
This chart shows conditions in which an administrator password is set
(is not 0000) and default password levels are used.