Konica Minolta Printer Copier - Manual (Page 150)

9 Troubleshooting Tips
9-2 Konica 7115/7118
The edge of the copy is dirty. The Original Pad is dirty. Wipe the Original Pad clean with a soft
cloth dampened with neutral
detergent. (p.10-5)
You have selected paper of a size
larger than the original (when the
zoom ratio is full size). Select the same paper size as the
original. (p.5-4)
Or, use Auto Size to enlarge the copy
to the appropriate size. (p.5-12)
The original is not placed in the correct
position (when the zoom ratio is full
size). Select the same paper size as the
original. Or, reload the paper in the
same direction as the original.
The reduction ratio selected is not in
accord with the paper size (when the
copy is made at a manually adjusted
reduction ratio). Select the zoom ratio according to the
paper size. (p.5-13) Or, use Auto Size
to reduce the copy to the appropriate
size. (p.5-12)
The image on the copy is not aligned
properly. The original is not placed in the correct
position. Place the original correctly on the
Platen Glass against the Original
Scales. (p.4-7)
Or, load it in the Automatic Document
Feeder correctly along the Document
Guide Plates. (p.4-3)
The original may not be suitable for
use in the Automatic Document
Feeder. Raise the Automatic Document
Feeder and place the original on the
Platen Glass correctly against the
Original Scales. (p.4-7)
The Edge Guide and Trailing Edge
Stop are not pressed up against the
paper stack in the tray. Slide the Edge Guide and Trailing
Edge Stop up against the edges of the
paper stack.
The paper has an excessive curl. Smooth out curl in the paper and
reload the paper stack in the tray.
Symptom Possible Cause Action
Konica7115_7118.book Page 2 Friday, October 19, 2001 12:02 PM