Kenwood XD-753 - Manual (Page 23)

23
Basic section
Selection of Tape Equalizer
÷
The Tape Equalizer is effective for reduction of
higher-frequency noise.
Select Tape Equalizer only when playing back a tape
recorded with Dolby Noise Reduction. (A tape recorded
without Dolby NR cannot be reproduced in normal au-
dio if Tape Equalizer is selected when playing it.)
Lights up when
Tape Equalizer is on.
Each press switches the modes as follows.
1 “T.EQ” ON ...... Tape Equalizer is used
2 “T. EQ” OFF ....... Tape Equalizer is not used
÷
If the tape transport direction is opposite to the desired
direction, press the play key corresponding to this.
÷
Normal (TYPE ) or high (TYPE ) tape selection is set
automatically.
÷
Remove tape slack before loading.
÷
Close the door securely.
The indicators (
2 , 3) indicate the current direction
in which the tape advances when playback or record-
ing is started automatically by the one-touch opera-
tion function, etc. This direction is the direction stored
in memory when the tape was last stopped.
(To switch the tape transport direction, press the play
key corresponding to the desired direction then press
the stop (
7) key.)
Transport direction indicators
Tape direction indicators of currently selected deck.
To wind tape at high speed
÷
Press the
7 key to stop fast winding.
Each press switches the modes as follows.
1 “ ” .... Playback stops after having played
both sides of tape in a deck.
(Relay play :
¢
)
2 “ ” ... Endless playback of both sides of
tape.
3 “ ” ...... Playback stops after having played
one side of tape.
Selection of reverse mode
To fast wind in
direction
\
To fast wind in
direction
|
To stop playback
÷
Do not take out the cassette tape until the tape
transport has stopped completely.
Reverse mode indication.
Lights up when a tape is present in the deck in use.
Displays the selected deck.
Let's have sound
REVERSE
MODE
TAPE EQ.
T.EQ
A B
T.EQ
A B
MU
LTI CONTROL