Kenwood XD-753 - Manual (Page 29)

29
Basic section
4. Select the source to be recorded.
The input source component to
be recorded should be displayed.
÷
If a disc has already been loaded when the CD input is selected, it will starts
to play automatically. In this case, press the stop (
7) key to stop it.
÷
When you select DVD/VIDEO (External input), adjust the input level. t
Select an input source other
than “TAPE A or B”.
1
Start recording.
2
Play (or tune) the input source to be recorded.
5. Start recording.
÷
If a disc has already been loaded
when the CD input is selected, it
will starts recording automatically.
÷
Even if deck A is selected, it is
automatically switched to deck B
at the start of recording.
÷
Recording stops automatically
when the tape side(s) to be re-
corded have been fully recorded.
÷
Press the stop ( 7) key of the cas-
sette deck unit to stop recording
(see the next page).
Lights
Let's record
To pause recording
(Main unit only)
÷
Pressing the key pauses recording after leaving a
non-recorded space of about 4 seconds.
÷
If the key is pressed again in less than 4 seconds after it
has been pressed, recording resumes from that instant.
Each press switches the modes as follows.
1 “ ” .... Recording stops after having re-
corded both sides of tape.
2 “ ” ... Recording stops after having re-
corded both sides of tape.
3 “ ” ..... Recording stops after having re-
corded one side of tape.
Selection of the reverse mode
Lights
÷
When the “ 2” transport direction indicator is lit,
recording always stops after having recorded one
side of tape.
REVERSE
MODE
REC/ARM
4 4
Press the desired key.
REC/ARM
5 5
C 2 D 0 1 1 : 1
T.EQ
A B
T.EQ
A B