Kenwood XD-753 - Manual (Page 33)

Application section
33
Playback of CD
1
Select “CD Program Play”.
2
Press the MENU key.
4
Check the programmed tracks
(and replace, add or delete tracks as
required).
To check:
÷
The blinking item can be replaced.
To replace a track in the program:
÷
The added track number is added to the end of the
existing program.
÷
The programmed tracks are displayed in sequence.
÷
Turn the MULTI CONTROL jog dial during program
playback to stop to the previous or next programmed
track.
÷
W h e n t h e j o g d i a l i s r o t a t e d a l i t t l e i n t h e
counterclockwise direction once during playback, the
track being played will be played from the beginning.
÷
To check (modify, add or delete) the programmed
tracks after playback, perform the operations in steps
2 and 4.
5
Enter it.
÷
If the key is pressed during playback, normal playback in
order of tracks resumes from the current track.
÷
The program mode can also be canceled by pressing
the
0 OPEN/CLOSE key.
1 Select the programmed disc
or track to be replaced and
press the SELECT key.
2 Select a disc or track to re-
place the disc or track selected
above (step
3-1and 2).
1 Select the display as shown
on the right and press the
SELECT key.
2 Perform the same operations
as in step
3-1and 2.
To add a track to the program:
To delete a track from the program:
1 Select the programmed disc
or track to be cleared and
press the SELECT key.
2 Select “clear” and press the
SELECT key.
Goes off
To quit the program mode
Display when 12 tracks have been programmed
Press the TIME key on the remote control unit to switch
the time display.
(Playback starts from the first programmed
track (program No. 1))
SELECT
SELECT
SELECT
ENTER
P 2 0 1 D 1 T 0
P 4 1 2 D 3 T 0
P 4 0 1 D 3 T 0
P ? 1 3 D ? T ?
P 4 1 2 D 3 T 0
P 1 2 c l e a r
MENU
SELECT
MENU
MU
LTI CONTROL
MU
LTI CONTROL
MU
LTI CONTROL
MU
LTI CONTROL
MU
LTI CONTROL