Kenwood XD-753 - Manual (Page 31)

31
Basic section
Copying tape
(Tape dubbing)
1 Select “ ” (double-side recording) or “ ”
(one-side recording). ª
2 Select “Tape Dubbing”.
The contents of the tape in deck A can be copied onto the tape in deck B.
÷
Dubbing ends automatically when the side(s) to be
dubbed has been fully recorded on.
Playing tape Recording tape
Load tapes in the decks.
+Scrolled display
(Tape Dubbing)
3 Use the same tape transport directions.
4
Start dubbing.
(1) Select the transport direction of deck A.
(2) Select the transport direction of deck B.
÷
When recording is started, the tape will be transported
in the direction selected in this step.
( > :side A, < : side B)
+Scrolled display
(Deck A Play Direction)
+Scrolled display
(Deck B Record Direction)
+Scrolled display (Press 'ENTER' to Start)
To stop dubbing
÷
The deck B will stop after creating a non-recorded
portion of about 4 sec, and then the deck A will stop.
÷
Dubbing can also be stopped by pressing the stop ( 7)
key of the cassette deck unit. Note that the non-
recorded space is not created in this case.
The TAPE EQ. key is ineffective during dubbing.
Let's record
The following items can be selected by turning
the MULTI CONTROL jog dial.
“Recording Options”
“Tape Dubbing”
“Audio Options”
“Clock Options”
“Language Options”
A A
REVERSE
MODE
SELECT
MENU
T i a p e D u b b
SELECT
ENTER
REC/ARM
SELECT
D a e c k A P l
A d e c k >
D c e c k B R e
B d e c k >
P T r e s s ' E N
MU
LTI CONTROL
MU
LTI CONTROL
MU
LTI CONTROL