Kodak Scanners i800 Series User Manual
Page 57
Advertising
5-14
A-61169 July 2003
6. Install each new tire by gently stretching it over the core.
IMPORTANT: Do not overstretch the tire; it may tear.
7. Replace the core assembly in the feed module.
8. Repeat Steps 4 through 7 for the other core assembly.
9. Align the tabs on the upper housing with the slots on the lower
housing.
10. Press the upper and lower housings together until they snap into
place.
11. Insert the feed module by aligning the pins and fitting it into position.
Verify that it is securely in place.
12. Close the swing out door.
Advertising