Kodak Scanners i800 Series - Manual (Page 58)

A-61169 July 2003 5-15
Separation roller and
tires This section provides procedures for changing the separation roller and
tires.
Replacing the separation
roller To replace the separation roller:
1. Open the swing out door.
2. Lift the roller cover.
3. Pull the separation pad holder forward and remove the separation
roller.
To install the new separation roller:
4. Pull the separation pad holder forward and put the new separation
roller in place.
NOTE: Be sure to line up the slots on the separation roller with the
holders.
5. Push the separation roller holder back in place.
6. Lower the roller cover.
7. Close the swing out door.