Kenwood AMPLIFIER/TUNER R-K1000 - Manual (Page 19)

English 19
Loading the remote control batteries
1 Remove the
battery cover.
2 Load the R03 batteries
supplied with the system.
3 Close the battery
cover.
Check the polarity of the
batteries (
U, V) when
loading them.
z
The batteries supplied with the system are only for operation checking and may only last for a short
time.
When replacing the batteries, always load 2 new batteries.
z
z
Component Names and Functions
Using the remote control
After plugging the main unit into the AC
wall outlet, press the power [
K] key on
the remote control unit to turn the system
on.
Once the system is turned on, press the key
for the function you want to use.
Point the remote control at the remote
sensor when using it.
The remote control may not operate
correctly if direct sunlight or light from a
high-frequency fl uorescent lamp (such
as an inverter type) is shining on the
remote sensor. If this happens, install
the main unit in a diff erent location to
avoid this sort of malfunction. z
Approx.
6 m
Approx.
30°
Approx.
30°