LOREX Technology L15LD400 - Manual (Page 27)

27
Recording Mode
Recording Mode
RECORDING STATUS
• Red Icon: Indicates the system is recording in Schedule, Motion or Alarm Mode.
• White Icon: Indicates that the record schedule is not set to record.
If the unit loses power, recording will automatically resume once power is restored (based on the
recording schedule setup). For more information on Regarding Mode Setup, please refer to the
RECORD SETUP on page
26-27.
NOTE: The system will stop recording when the following occur:
• No camera video inputs are detected (the cameras are not attached to the system).
• Motion is not detected (when the record mode is set to MOTION).
• When the record schedule is set to Not Record.
• If the HDD is not formatted, or when using the factory defaults after a new HDD is installed.
• When the Overwrite function is OFF, and the HDD full.
• When the system is copying Backup data.
• When the firmware is being updated.
• When the system is in the HDD management section of the Setup Menu.