LOREX Technology L15LD400 - Manual (Page 52)

52
Connecting PTZ Cameras - Appendix #6
Connecting PTZ Cameras - Appendix #6
PTZ Cameras (not included with this system) can be connected to the PTZ Control Block on the
back panel of the System. The PTZ Controls are enabled through the Menu system on the
Observation System. Additional PTZ Cameras are available at http://www.lorexcctv.com
Installing a PTZ (RS-45 Type) PTZ Camera:
1. Connect the Transmit Cable to the D+ port on the PTZ Control Block on the Observation System.
2. Connect the Receive Cable to the D- port on the PTZ Control Block on the Observation System.
3. Connect the Camera to BNC Channel 1 (DIN Channel 1 must be empty).
4. Configure PTZ Menu options - refer to page
25. The PTZ Camera Settings will depend on the
Type of Camera - refer to the specific Camera Manual for your brand and model of PTZ Camera.
• MODEL - Select a PTZ protocol
• PTZ ID - Enter the PTZ’s ID / address.
• BAUD RATE - Enter the PTZ’s transmission baud rate
• CMD DELAY - Set the delay time of the command transmission between bytes. Please refer
to the PTZ user manual for the manufacturer’s recommendations.
PTZ CAMERA
(Not Included)
OBSERVATION SYSTEM